FSS Inc. - Fred's Sharpening Shop and Bill's Decorative Copper

call 229-435-4471 M-F 10:00A-6:00P Sun 1200N-600P

Archive

Newer | Older

Monday, July 20, 2009

State Firearms License

I now have my GA state firearms license. This allows for the sale of firearms that are less than 14" in length. Now I will go downtown and get my local business license. To recap, in order to be able to alter or make arms or make ammo in GA for sale to the public, you must have an 07 FFL, a GA state license, a local business license and a county issued concealed carry permit. Why the carry permit? Can't get the business license. Go figure. Oh well! I now have all four licenses and am ready to go. Next project is to cut the pieces that go into a die press that will make the brass cartridges for the ammo. This will be a six month job. Stay tuned.

20 jul 09 @ 1:23 pm edt Comments

Archive

Newer | Older

Bill Slugg - Owner/Operator

Fred's Sharpening Shop
1820 Ledo Road
Albany, GA 31707
229-435-4471

M-F 9:30AM until 6PM

Mower blades - $2 off the mower.

Saw chain on the saw - $5

Saw chain off the saw - $3

Note: Saw chains must come off the saw because they have to go on to a machine in order to be sharpened.

Loppers - $5

Hedge shears - $5

Gas or electric Power hedge trimmers - $10

Carbide circular saws - $.20 per tooth - simple alternate top bevel (Most saws)

Carbide circular saws - $.30 per tooth - triple chip or other advanced tooth form

Planer blades - $.50 per inch of ground edge

Chipper blades - $1 per inch of ground edge

Drill bits - $.50 to $1 for 1/8" to 3/4".

I can do spiral drill bits from .006" up to 3".

Mueller Shell Cutter Re-toothing

Shell cutters for hot tapping water/gas/steam lines - Why send them (12") off to Mueller to have them rebuilt for $1600 when I will do it for $800? Call me for instructions.

I can straighten horizontal boring pipe. I will get the bend down to <1/8" for $20 apiece.

A few things I cannot do:

Electric hair clippers - Send entire machine back to the manufacturer or to someone on the net who advertises the ability to sharpen them AND wants to see the entire machine. Many cutting problems are due to springs, linkages, pivots, clamps, tension, etc.

Spiral tooth forms such as end mills - no plans to handle these.